I think my SD card died, how to restart again as quickly as possible?

[tomvdhorst]

Burn a new image of the piaware SD card

PiAware - build your own ADS-B ground station for integration with FlightAware...

Start with step 2
from there on you will need to reregister your orignal station ID

For Beginners - How to Get Back Existing Station Number in A Fresh Install

Go to your stats page while logged-in, by clicking following link: https://flightaware.com/adsb/stats/user/ If you have only one station in your account, go to step 3. If you have more than one ststion, select the station number you want to restore. Copy the Unique Identifier (see screenshot below) Give following command (Replace xxxxxxxx-xxxx-xxxx-xxxx-xxxxxxxxxxxx by the Unique Identifier you have copied from your stats page) sudo piaware-config feeder-id xxxxxxxx-xxxx-xxxx-xxx…

Then you can reinstall Graphs1090 again.

I could use a Coach

Graphs1090 wil give you a visual insight in how well the receiver is performing. This will enable you to correct some settings in order to improve the reception of your setup. In order to install graphs1090 you have to take the following steps: Open a Putty session towards your system. Copy the following line via the Ctrl + C buttons from your screen into the Putty session sudo bash -c "$(curl -L -o - https://github.com/wiedehopf/graphs1090/raw/master/install.sh)" right-click inside the P…

Lastly, set the gain correctly for your station as you had it in the previous install.

Your SD card might not be dead but your software installation could be corrupted. This might indicate the card is on the brink of going dead ( my expierence)