How to Install and Configure Piaware 5.0 SD card image - Quickstart Guide

I am located at Toronto, Canada, which has only occasional UAT traffic. Whenever I look to Skyview978 map, it is empty. In last 3 weeks, only on two occasions there were UAT978 flights when I viewed the map. These also disappeared within 15 minutes.

To monitor the UAT978, I installed performance graphs by @wiedehopf. By viewing these graphs, I know how many flights my receiver has picked during last 24hrs, or last 7 days, or last 1 month.

https://discussions.flightaware.com/t/piaware-sd-card-image-3-7-0-1-quickstart-guide/48262/205

Here is the thread goving details & installation method of the graphs:

Graphs for dump1090 – my version with install script

To summerize, to install the graphs, it only requires to issue following command:
(Scroll right to see full command)

sudo bash -c "$(wget -q -O - https://raw.githubusercontent.com/wiedehopf/graphs1090/master/install.sh)"  

To see the graphs in browser:

IP-of-Pi/graphs1090/

The graphs wont show immediately after installation. They appear about 10 minutes after installation because these are collecting data to populate graphs.

Graphs update automatically at an interval of about I think 10 minutes.

At anytime to update the graphs issue following command:

sudo /usr/share/graphs1090/graphs1090.sh 24h

Then reload browser (Ctrl+F5)

NOTE:
To see UAT978 graphs, scroll down to bottom. The bottom 3 graphs are for UAT978.

2 Likes