Adding 978 Traffic to v6.1?

[abcd567]

 
@phodge

Did you configure as shown in step “6 - Configure UAT 978” below?

 

@abcd567

5 - Serialize dongles if using UAT 978: (CLICK HERE)

If you want to recieve both ES1090 and UAT978, then two dongles are required, one for 1090 and other for 978. In this case you will have to serialize dongles so that correct dongle+antenna sets are used by dump1090-fa and dump978-fa.

For 1090 Mhz dongle: use 8-digit serial # 00001090
For 978 Mhz dongle : use 8-digit serial # 00000978

Note: You can use any other serial numbers if you want, but do not use single digit serial numbers (0 to 9) or (01 to 09), as these may conflict with device numbers. Use at least two digit numbers like 21 or 93 etc)

6 - Configure UAT 978

sudo piaware-config uat-receiver-type sdr
sudo piaware-config rtlsdr-device-index 00001090
sudo piaware-config uat-sdr-device driver=rtlsdr,serial=00000978

# Reboot Pi to implement configuration settings
sudo reboot

7 - Check Status

sudo systemctl status piaware  
sudo systemctl status dump1090-fa  
sudo systemctl status dump978-fa  

8 - View Maps

8.1 - dump1090-fa map
http://local-ip-of-pi/dump1090-fa/
http://local-ip-of-pi:8080/

8.2 - dump978 map
http://local-ip-of-pi/skyview978/
http://local-ip-of-pi:8978/